Nodiz Pro Ignition ECU, Vauxhall Plug and Play Pack (Gen 2)

  

If you have the factory Coil Pack and Crank Sensor on your Vauxhall Engine, and are using carbs for fueling, then this package is EVERYTHING you need to have it up and running in MINUTES! The innovative Nodiz Pro Ignition Management ECU. Ideal for use alongside our bike carb kits or the more traditional carburettor set-ups.

The NODIZ Pro is a state of the art microprocessor controlled digital stand-alone, fully mappable ignition controller for 4 or 8 cylinder spark ignition engines. It can be used either to replace older distributor based ignition systems for more modern coil packs, or even to allow the running of carburettors on more modern engines which do not feature a distributor drive. 16 Load by 16 Speed Sites, with full 3D interpolation and user definable Speeds/Loads. User settable RPM Soft and Hard Cut Rev Limiters. In-built coil drivers, no need for EDIS or other modules.

Coolant based ignition adjustment map To add advance to cold engines, etc. Intake Air Temperature ignition adjustment map, to allow timing retarding based on intake temperature to reduce pinking on very high intake temperatures.

Cranking based advance angle to help start high compression engines. A programmable Shift Light output.

A programmable output based on either RPM i. V-TEC control, coolant temperature i. Fan Control or Intake temperature i.

RS232 Connectivity Port for cable connection. The unit will require configuring to the Vauxhall settings prior to startup. This will involve connecting with a laptop/PC and changing the Trigger pattern from 36-1 (Ford) to 60-2 (Vauxhall) and adjusting the Trigger offset from 90degs (Ford) to 68degs (Vauxhall). It is also advised that once up and running a traditional timing light is used to double check you are seeing the correct timing at idle - fine tuning of the Trigger offset can be done if any variation is found.

Details of these procedures are outlined in the manual (available online). Full support and documentation is available from both danST Engineering and Motorsport Electronics. Our customer service is available 24 hours a day. Thank you for your interest in our company, we hope that you will be satisfied with the service and quality of our products! Check availability with our specialists.

It can be used either to replace older distributor based ignition systems for more modern coil packs, or even to allow the running of carburettors on more modern engines which do not feature a distributor. The item "Nodiz Pro Ignition ECU, Vauxhall Plug and Play Pack (Gen 2)" is in sale since Tuesday, January 15, 2019. This item is in the category "eBay Motors\Parts & Accessories\Commercial Truck Parts\Engines & Components\Other Engines & Components". The seller is "dansteng" and is located in Shipley. This item can be shipped worldwide.

• Other Part Number: NODIZ-003
• Brand: Motorsport Electronics
• Manufacturer Part Number: NODIZ-003
• Country/Region of Manufacture: Unknown