Ford Duratec 2.5L Inlet manifold for Weber/Jenvey DCOE Throttle bodies, 20deg. An inlet manifold to suit the Ford Duratec.
TIG welded in aluminium and fully internally ground to ensure optimum flow and performance. This manifold is designed for the standard Weber/Jenvey DCOE type mounting and can be made with 45mm, 48mm or 50mm bore mounting plates. The spacing between carbs 2-3 is 93mm, however this can be adjusted if required (depending on your linkage). Please specify throttle body port size, if this hasnt been specified we will automatically send a 45mm port. Please Note that this is for the 2.5l Version of the Ford duratec engine and has larger ports than the 1.8/2.0/2.3.
The manifold includes a single servo connection - these can be blanked off if not required, please advise when ordering. Technical drawings are available on request and custom lengths and heights can be accomodated, please message us with your requirements. If you require any additional vacuum take-offs adding to the manifold or a.Our customer service is available 24 hours a day. Thank you for your interest in our company, we hope that you will be satisfied with the service and quality of our products! Check availability with our specialists. Please Note that this is for the 2.5l Version of the Ford duratec engine and has larger ports than the 1.8/2.0/2.3 The manifold includes a single servo connection - these ca. This item is in the category "eBay Motors\Parts & Accessories\Commercial Truck Parts\Engines & Components\Other Engines & Components". The seller is "dansteng" and is located in this country: GB. This item can be shipped worldwide.